Modeling Omega Tropic Tutorial by EL_Shadow [TeknoBrothers®]
Press "ALT+W"; on your keyboard to access the four view ports. Highlight the Left view port and maximize by hitting "ALT+W";, again on your keyboard. Select all vertexes and align them by following the hood with the vertexes.
By now, you may already know how to access different view ports so, I'll no longer tell you how to access the view ports.
At the top view port, using the cutting tool - located at the "Edit Geometry"; rollout – create the line shown below by cutting the patch. Just follow the hood edge near the headlight.
Notice: Don't forget to zoom the area where you want to work on to increase the accuracy. If you forgot how to access the "Zoom Region"; tool, just press "CTRL+W"; on your keyboard.
Highlight the front view port and press "V"; on your keyboard. From the popup menu that appears, select "Back View";. You should see right now the front blueprint of the car instead of the rear one.
If you look carefully at the front view port, you'll notice that the edge line you just created around the headlights almost coincides with the one from the Vipers headlights. In this case we'll not have the hard work to adjust the vertexes around the headlights from the viper's blueprint.
Select the three vertexes as shown below and DELETE them. (I'm sure you know how to delete them).
By using the cutting tool (you know where to find it), create a line shown below by cutting the patch.
On the top view port, select those two vertexes you just created and move them upwards until you see a straight wire line.
As both bumpers from Tiburon and Viper are rounded, let's create conditions the put it rounded too. Select the same two vertexes selected before then, the other two located above and below them. Move them upwards so you can see the same as you see below:
If this is your first followed tutorial, don't forget to learn the basics but, until that day comes, let me fulfill you with such wisdom. Let's stop for a little so you can learn the basics, if you don't know them already. You can skip this step if you already know the basics.
If you carefully look above the view port, you'll be facing the main toolbar. By looking at the picture below, you'll find there the description of the basics, only the basics:
