GP2 Modeling, Rendering and Compositing Tutorial

This sidepod funnel took a while to do because of some technical parts. From the vector drawing I imported, I did the same process as the wheel mug. I extracted the shape and after couple of hours I was able to form the correct shape as in the blue print.

To get a proper balance, after modelingone side of the sidepod I copied (ctrl+v) and input value of 0,0,0. This will make exact same copy symmetrically on the right side. Afterchecking and comparing with the blue print I deleted the right side and continue editing the left sidepod.

I added gills on the sidepod funnel.

Sidepod wings added, again created from box.

Below is about 85% done model.

Rear wings added. Noticed the side panel, once in a while I use bolean operation but as much as possible I limit the use as it's too ugly to look at.