Mazda RX8.
The Spoilers
By now we should be ready to get on with the spoilers, so lets take a look at the car so far. The spilers are a bit tricky because they are not as plane as the rest of the car, but lets get to work.
Go to the front of the car and shape the spoiler, the places where the air filters are you just delete the polygens and drag the edges inwards to get a hole like shape. This bit requires a lot of welding, be careful not to make to many segments because it may disturb your smooth.
Lets se the car with a meshsmooth of 2. The spoilers are a vital part of the car, because they make it look really good, so work hard on them and be pacient.
Cutting
Because we have shaped the whole car out of 1 plane, we need to cut out the doors and etc. Go to the edge selection an go down to "Cut".
Now you can cut out the shape of the door. You dont have to be all that precise because we gonna make it fit with the meshsmooth on.
Now go to the polygen selection and choose all the polygens that make out the door, choose detach "to object" and name it door. Dont choose anyone of the detach options...
Your door should look like this, you can continue cutting out the various shapes like the windows in the door. Use the detach option for the front hood and the bach hood the spoilers and so on...
Now you just have to make a lillte room between the door and the rest of the body, so they dont look like their one big piece. I usually make a difference of about 0,5 that seems to the job.
With the meshsmooth on you should have something like the picture below. If not go back a few steps and try again. Remember also to save your work at various points in a new file.
