Mazda RX8.
Shaping The Body
Again you choose the outer edges of your plane and then you run them along side the body of the car, make 2 or 3 stops un the way so that you create some segments for later use.
Now we need to shape the back of the car were the wheel is going to be, here we use a little copy and paste system. Go to your editable mesh and choose "Polygen", then select the first shape you did "Like below", hold down shift and drag it to tha back end of the car.
Make the copied selection fit to the blueprint and connect it to the rest of the plane. You connect it by welding the vertex?ses togehter. Make the vertex?ses be in the exact same position and then choose " Weld --> Selected " if their not in the same position you will get a notice from the Program...
You should have something like this now, keep on shaping the rest of the body and remember to shape in all viewports!
The Body 2
Now we are going a bit upwards, we are going to shape the rest of the body. Select the upper edges of your plane where the windows start. Again hold down shift and drag them upwards, remember to make some segments on the way.
Also drag the front hood inwards like shown down under... Still shaping the plane after the blueprints.
Now lets take a look at the car so far, with the symmetry on it should look like the picture below. Keep on making the roof and the back hood, and remember to shape in all viewports!
3DM3 on Twitter
3DM3 on Facebook
Subscribe RSS