Wow, its ages since I've been to this place. Its changed so much!
I'm back though, and probably back for good
I hope you welcome me back after so long
I started work on this model a couple of months back (I'm still slow at modelling, but I think I've improved alot).
Its a model of the Logitech Z-5500 speaker system, and I was planning to model the entire set, speakers/pod/sub/controller and make a studio setup, and possibly a fake advertisement animation.
I know to a lot of people, its probably just another realistic type model thats been seen many times before, but the amount of work I've placed into this, trying to get it as accurate as possible (especially the latest pod model), is something I've never done before, and any feedback would be fantastic.
I've already modelled the front/rear speakers, and the pod. All thats left now is the centre speaker stand, and the sub, and finally the controller.
Its all clay at the moment, but I will proceed to texture/shade the models after completion, because I really get thrown off otherwise, as I've learnt from past experience.
I use Max, and Vray as the renderer as standard
I hope you like, and sorry about the long read :p
RENDERS:
Speaker model:
Speaker wire:
Very early material test:
Control pod finished, with speaker:
Control pod back:
Control pod wire (The back may need doing again for cleanliness, but it renders fine)
Thanks for looking :) Any comments welcome